Laserfiche WebLink
<br />f1. <br />n <br /> <br />n <br /> <br />o <br /> <br />o <br /> <br />o <br />o <br /> <br />o <br /> <br />o <br />o <br /> <br />o <br /> <br />o <br />[] <br /> <br />[J <br />D <br /> <br />D <br /> <br />u <br /> <br />u <br /> <br />u <br /> <br />4. Functional Tests <br /> <br />Test Spec. Mode Test Procedure Expected Pass Fail Notes <br />ID Section . Response <br /> 15950 <br /> . <br />1 3.09 B Occupied UniconvnandedtooccupMd Verify by visual X <br /> mode by BAS inspection Ihal OA <br /> Dampers open 10 <br /> minimum position. <br /> Supply Fan operallonal. X <br /> Supply fan status reads X NOIe 3 <br /> . on computer <br /> Return Fan operational. X . <br /> Return fan status reads X Note 4 <br /> on computer <br /> 3.G9 E Turn the supply fan 10 Ihe off Verify _ alann is X NoleS <br /> position. generated. OA dampers <br /> close & unit continues <br /> to run. <br /> Tum the return fan to the off Verify that aIann is X NoleS <br /> position. generated, OA dampers <br /> close & unit continues <br /> to run.. <br />2 3.091 Morning Unit COI,..Nauded to morning Verify SF & RF are on. X Note S <br /> wann up warm-up by BAS.lNAC Sequence} I <br /> outside & relief dampers X Note I <br /> are closed. NoIe 12 <br /> RA dampers are open. X NoIel <br /> Discharge lemperature X NoIel <br /> is controlled at <br /> 9Sdegrees. <br /> DX cooling conlrol X Nolel <br /> relays are olf. <br /> <br />Notes: Testing of AHU #2 was performed using HVACPro. <br />,. Main computer is not setup for alarms. U.N.T. conlroller is not programmed properly. pressure will always read O. <br />2. Unable to lest because of outside air temperature. <br />3. Supply fan status does not work. Status continuaHy shows on. <br />4. Return fan. (IF.2) has no points on controller. <br />5. Unit continues 10 operate . either fan fans. <br />6. Conlroller is not programmed for warm up mode. <br />7. Economizer mode is locked out on 0'- a~ Iernperalure set point. <br />8. ox. cooling is never locked out. Outside air temperature is not being written 10 controller and set point for lockout is at 20". <br />9. Low tim~ protection device is wired 10 1he supply fan status point. No alarm is generated. <br />10. Opening contacts oodnhhuf down unit. No alarm is generated. <br />11. Main computer is not setup for aJarms. U.N.T. controltef is not programmed properly. pressure will always read OHler status is <br />not on computer. <br />12 Relief damper actualor is not installed. Damper is installed and in 1he open position. <br /> <br />File: AHU2_FinaIReport.doc <br /> <br />Page 4 of 6 <br /> <br />. <br /> <br />. <br /> <br />. <br />