Laserfiche WebLink
DRAFT <br /> Revised July 7. 1998 <br /> development recreational <br /> lakes: urban, development Natural <br /> *Average agricultural, lakes: environment <br /> unit floor tributary transition and lakes and <br /> area (sq. river forested river remote river <br /> ft.) segments segments segments <br /> 200 .040 .020 .010 <br /> 300 .048 .024 .012 <br /> 400 .056 .028 .014 <br /> 500 .065 .032 .016 <br /> 600 .072 .038 .019 <br /> 700 .082 .042 .021 <br /> 800 .091 .046 .023 <br /> 900 .099 .050 .025 <br /> 1,000 .108 .054 .027 <br /> 1,100 .116 .058 .029 <br /> 1,200 .125 .064 .032 <br /> 1,300 .133 .068 .034 <br /> 1.400 .142 .072 .036 <br /> 1,500 .150 .075 .038 <br /> *For average unit floor areas less than shown, use the floor area ratios listed for <br /> 200 square feet. For areas greater than shown, use the ratios listed for 1,500 <br /> square feet. For recreational camping areas, use the ratios listed at 400 square <br /> feet. Manufactured home sites in recreational camping areas shall use a ratio equal <br /> to the size of the manufactured home, or if unknown, the ratio listed for 1.000 <br /> square feet. <br /> C. Multiply the suitable area within each tier by the floor area ratio to <br /> yield total floor area for each tier allowed to be used for dwelling <br /> units or sites. <br /> D. Divide the total floor area by tier computed in Item C. above by the <br /> average inside living area size determined in Item A, above. This <br /> yields a base number of dwelling units and sites for each tier. <br /> E. Proposed locations and numbers of dwelling units or sites for the <br /> commercial planned unit development are then compared with the tier, <br /> density and suitability analyses herein and the design criteria in <br /> Section 8.6. <br /> 8.53 Density Increase Multipliers: <br /> A. Increases to the dwelling unit or dwelling site base densities <br /> previously determined are allowable if the dimensional standards in <br /> Section 5.0 are met or exceeded and the design criteria in Section 8.6 <br /> are satisfied. The allowable density increases in Item B. below will <br /> only be allowed if structure setbacks from the ordinary high water <br /> level are increased to at least 50 percent greater than the minimum <br /> setback, or the impact on the waterbody is reduced an equivalent amount <br /> through vegetative management, topography, or additional means <br /> acceptable to the local unit of government and the setback is at least <br /> 25 percent greater than the minimum setback. <br /> B. Allowable Dwelling Unit or Dwelling Site Density Increases for <br /> sMO- 260.081 -39- 260- 081-10 <br />