Laserfiche WebLink
c. consider convenience of homeowner <br /> d. room for installation and future access <br /> e. consideration for Touch-Read touch pad installation. <br /> 2. install MIU at selected location using minimum of two sheet metal screws <br /> and /or cable ties. <br /> 3. if not already accessible, install a phone connection terminai within 18" <br /> O F RJI1 connector of MIU (see illustration 1) and connect to exisi. ^.c <br /> telephone network- A phone connection terminal with an R M conneci� <br /> o is <br /> recommended. If telephone connection terminal is to b n t n. <br /> t <br /> e isalled <br /> Outdoors, the RJll receptacle must be waterproof type- A waterproc_ <br /> contact lubricant is also recommended for all R511 cor_nections if t'' =e =C <br /> is being installed outdoors or in high humidity locations such as a camp <br /> basement. Follow installation instruc Drovided With the phone <br /> connection terminal. <br /> riAR2TING! DC -NTOT use telephone compa nv's protector block as a connect or <br /> noLnC if a standard network inte -face is connected to _..e Protector b].oc:F. <br /> r violation o locl telephone <br /> irect connection to the protec ..o_ may be in <br /> company regulations. Also, before connecting to any alarm system incertace <br /> ck, co nsult with the ala- company - <br /> VO MIU can only be connected to a, analog loopstart phone 1i., <br /> ins- ailinc in existing dicital telephone environment, an analog phone lire <br /> must be erovided. <br /> r. Connecting encoder registers to '?Iu inside _ type ecisters: <br /> a. Measure distance between ECR and meter; cut three conductor cable CO <br /> connect encoder register to y1 m <br /> iII. (Do net exceed maxium lend: o_ 250 <br /> ft.) <br /> b. Strip approximately two inches of outer insulation from both ends of <br /> three conductor cable. (Figure 1) <br /> c. Strip approximately 3/8" of the insulation from each of the three <br /> internal wires. (Figure 1) <br /> c. Connect one end of three conductor cable to encoder register as marked <br /> on register: <br /> (Red to R; Black, Yellow or White to B; Green to G) <br /> e. Connect MIU end of cable to desired port (Port 1 for single meters) of <br /> MIU as marked on inside MIU protector plate. (Red to R; Black, Yellow <br /> or White to B; Green to G) for Sensus encoder registers. Se sure to <br /> check that insulation is not trapped under screw of terminal block and <br /> no bare wires are making unintended contact. (Figure 2) <br /> f. For touch pad installation, connect two conductors of 3- conductor cable <br /> to position marked "TP and "TP" at Port 1 for 1 meter and Port 2 for <br />