Laserfiche WebLink
<br />Co-Location Technical Data Sheet <br /> <br />us West has the following parameters: <br /> <br />PCS 12 Block, Actual Channels Used: <br /> <br />325,350,375 <br /> <br />Base Station Tx Frequencies: <br />Base Station Rx Frequencies: <br /> <br />1946.25 MHz, 1947.5 MHz, 1948.75 MHz <br />1866.25 MHz, 1867.5 MHz, 1868.75 MHz <br /> <br />Modulation I Standard: <br />Maximum EIRP: <br />Channel Bandwidth: <br /> <br />Direct Sequence Spread Spectrum I CDMA IS-95 <br />+53dBm (37dBm + 16dBi gain Antenna) <br />1.2388 MHz <br /> <br />Antenna Information: <br /> <br />Antenna Size <br />42" x 4.5" x 4" <br />Weight = 15 lb. <br />including mounting <br />hardware <br />(Desired) U S West PCS Antenna Height 10 - 15 ft above surroundin~ clutter (center of antenna) <br /> <br />Swedcom SP9014-DIN <br />Gain = 16dBi <br />Azimuth Beam Width = 900 <br />Elevation Beam Width = 80 <br /> <br />Standard Antenna Configuration: <br /> <br />2 antennae per sector <br />3 sector design, 1200 each <br />Center of sectors at 00, 1200, & 2400 w.r.t TRUE NORTH <br />Horizontal Spacing:. 3 ft to 6 ft. depending on antenna height. <br /> <br />Governing FCC Rules: <br /> <br />Code of Federal Regulations <br />Title 47 (Telecommunications) <br />Part 24 (subpart E) <br /> <br />Out of Band Emissions: <br /> <br />Section 24.238 (a) on any frequency outside a licensee's <br />frequency block, the power of any emission shall be <br />attenuated below the transmitter power (P) by at least 43 + 10 <br />log(P)dB. This is an FCC requirement Below are the <br />equipment specifications: <br /> <br />Note that F = Frequency of other party and Fbe = Frequency <br />at Block Edge, for E-block Fbe = 1945 and 1950 MHz <br /> <br />Out of block: <=-13dBm/12.5kHz for [F-Fbe] <=1 MHz <br /><= -13dBm/Mhz - 1.2 dB/MHz [F-Fbe} for 1 <br />MHz < [F-Fbe] < 65 MHz <br /><= -90 dBm/MHz for [F-Fbe] 6S MHz. <br /> <br />Intermodulation Levels: <br /> <br />Less than -125 dBm delivered to the antenna, at the IdB <br />compression point ofTx amplifier. <br /> <br />AC power requirements: <br /> <br />AC input voltage: 208/240 V AC, 50/60 Hz, single phase <br />AC input current: 35 Arms @ 180 Vrms @ 2KW DC <br />output. <br /> <br />.. <br />