2016-05-24_PWETC_AgendaPacket - Laserfiche WebLink

Home

2.In the event that a sewer service exists from the main sewer to a point outside of the street,the contractor shall excavate and expose the upper end of the service pipe.The elevation of the pipe leaving the structure shall be determined,and the difference between the two pipes shall be sufficient so that a minimum grade of one-eighth inch per foot is maintained.(1990 Code) D. Alignment:No connecting sewer shall contain bends or a combination of bends which at any point shall be greater than 45 degrees,and no more than two bends,regardless of angle, shall be permitted in any single house connection except where manholes or,in case of slab home,cleanouts are constructed at such points and in manner as directed by the Public Works Director.No connecting sewer shall be laid parallel to any bearing wall or footing unless further distant than three feet from any such bearing wall or footing.No connecting sewer shall be laid within 20 feet of any existing well.(Ord.234,8-6-57) E. Trenching and Backfilling: 1.All excavations shall be open trench work unless otherwise authorized by the City Engineer.The foundation in the trench shall be formed to prevent any subsequent settlement of the pipes.If the foundation is good and firm earth,the earth shall be pared or molded to give a full support to the lower third of each pipe.Bell holes shall be dug to provide ample space for pouring of joints.Care must be exercised in backfilling below the center line of the pipe in order to give it proper support. 2.Backfilling shall be placed in layers and solidly tamped or packed up to two feet above the pipe.Backfilling shall not be done until the section to be backfilled has been inspected and approved by the Public Works Director. F. Use of Existing Sewer Services:Existing sewer services or portions of such sewers may be approved for use by the Public Works Director.The Public Works Director may request that the old sewer be excavated for the purpose of facilitating inspection.No cesspool or septic tank shall be connected to any portion of a house sewer that is also laid across or over any existing cesspool or septic tank�the existing cesspool or septic tank shall first be pumped clean and filled with earth to the surrounding ground level.Where a sewer is laid across or over any existing cesspool or septic tank,only material approved by the Public Works Director shall be used for that portion of the connecting sewer which is laid across or over the existing cesspool or septic tank. G. Connections at"Y"Only:Every connecting sewer shall be connected to the Municipal sewer system at the"Y"designated for the property served by the connection,except where otherwise expressly authorized by the Public Works Director.Where expressly authorized by the Public Works Director,all connections made at points other than the designated"Y" shall be made only under the direct supervision of the Public Works Director in such manner as the Public Works Director may direct. H. Sump pumps: 1. All new 4nd existing structures with sumps for which a building permit is issued shall be �mmentiw�ELS21.�AddedLangu�age �::::::] plumbed to the outside of the dwelling and inspected by City personnel before a certificate of occupancy is issued.A sump pump discharge system shall not be connected directly or indirectly to the City's sanitary sewer system.A sump pump shall have a permanently installed discharge line,which provides for year-round discharge to the outside of a building or structure.�he discharge line shall be terminated on private property and not in public right of way unless approved by the Public Works Director.The discharge line shall not discharge water in locations that would cause negative impacts to adjacent property owners or the public.It shall consist of a rigid discharge line inside the dwelling or building,with glued fittings that do not contain unions for other than pump service,bypass valves or apparatus inside the dwelling or building that allow for altering the path of 16