CCP 04242023 - Laserfiche WebLink

Home

(2) be built on a permanent chassis and anchored to pin foundations with engineered fasteners; If this is not done by 6/2, PoP will provide a date by which it will be done. (3) have exterior materials that are compatible in composition, appearance, and durability to the exterior materials used in standard residential construction; (4) have a minimum insulation rating of R-20 in walls, R-30 in floors, and R-38 in ceilings, as well as residential grade insulated doors and windows; (5) have a dry, compostable, or plumbed toilet or other system meeting the requirements of the Minnesota Pollution Control Agency, Chapters 7035, 7040, 7049, and 7080, or other applicable rules; PoP will provide documentation of a dry or compostable toilet in the homes. (6) have either an electrical system that meets NFPA 70 NEC, section 551 or 552 as applicable or a low voltage electrical system that meets ANSI/RVIA Low Voltage Standard, current edition; (7) have minimum wall framing with two inch by four inch wood or metal studs with framing of 16 inches to 24 inches on center, or the equivalent in structural insulated panels, with a floor load of 40 pounds per square foot and a roof live load of 42 pounds per square foot; and (8) have smoke and carbon monoxide detectors installed. (b) All micro units, including their anchoring, must be inspected and certified for compliance with these requirements by a licensed Minnesota professional engineer or qualified third-party inspector for ANSI compliance accredited pursuant to either the American Society for Testing and Materials Appendix E541 or ISO/IEC 17020. This needs to be done after anchoring; by 6/2 PoP will provide a date by which this can be done. (c) Micro units that connect to utilities such as water, sewer, gas, or electric, must obtain any permits or inspections required by the municipality or utility company for that connection. PoP will provide documentation by 6/2. (d) Micro units must comply with municipal setback requirements established by ordinance for manufactured homes. If a municipality does not have such an ordinance, micro units must be set back on all sides by at least ten feet. PoP will provide documentation by 6/2. EFFECTIVE DATE. This section is effective January 1, 2024.