2023_0725_PWETCPacket - Laserfiche WebLink

Home

REGULATIONS I WATER 19 .4 :&'m COX63 : AL (Action Level): The concentration of a contaminant which, if exceeded, triggers treatment or other requirements which a water system must follow. EPA: Environmental Protection Agency MCL (Maximum contaminant level): The highest level of a contaminant that is allowed in drinking water. MCLs are set as close to the MCLGs as feasible using the best available treatment technology. MCLG (Maximum contaminant level goal): The level of a contaminant in drinking water below which there is no known or expected risk to health. MCLGs allow for a margin of safety. MRDL (Maximum residual disinfectant level): The highest level of a disinfectant allowed in drinking water. There is convincing evidence that addition of a disinfectant is necessary for control of microbial contaminants. MRDLG (Maximum residual disinfectant level goal): The level of a drinking water disinfectant below which there is no known or expected risk to health. MRDLGs do not reflect the benefits of the use of disinfectants to control microbial contaminants. NA (Not applicable): Does not apply. NTU (Nephelometric Turbidity Units): A measure of the cloudiness of the water (turbidity). ppb (parts per billion): One part per billion in water is like one drop in one billion drops of water, or about one drop in a swimming pool. ppb is the same as micrograms per liter (Ng/1). ppm (parts per million): One part per million is like one drop in one million drops of water, or about one cup in a swimming pool. ppm is the same as milligrams per liter (mg/1). TT (Treatment Technique): A required process intended to reduce the level of a contaminant in drinking water. *The percentage of Total Organic Carbon (TOC) removal was measured each month. The system met all TOC removal requirements, unless there is a "No" under the Meets Standards column. ABOUT THESE RESULTS This report contains our monitoring results from JAN. 1 - DEC. 31, 2022 We work with the Minnesota Department of Health to test drinking water for more than 100 contaminants. It is not unusual to detect contaminants in small amounts. No water supply is ever completely free of contaminants. Drinking water standards protect Minnesotans from substances that may be harmful to their health. Learn more by visiting the Minnesota Department of Health's web page Basics of Monitoring and Testing of Drinking Water in Minnesota at: tinyurl.com/y653g4on. The table on pages 8 and 9 shows the contaminants we found last year or the most recent time we sampled for that contaminant. They also show the levels of those contaminants and the Environmental Protection Agency's limits. Substances that we tested for but did not find are not included in the table. We sample for some contaminants less than once a year because their levels in water are not expected to change from year to year. If we found any of these contaminants the last time we sampled for them, we included them in the table with the detection date. We may have done additional monitoring for contaminants that are not included in the Safe Drinking Water Act. To request a copy of these results, call the Minnesota Department of Health at 651-201-4700 or 1-800-818-9318 between 8:00 a.m. and 4:30 p.m., Monday through Friday. Some contaminants are monitored regularly throughout the year, and rolling (or moving) annual averages are used to manage compliance. Because of this averaging, there are times where the Range of Detected Results for the calendar year is lower than the Highest Single Test Result, because it occurred in the previous calendar year. Page 37 of 76