12-01-14-WS - Laserfiche WebLink

Home Browse Search

DRAFT November 25, 2014November 20, 2014November 10, 201 TCAAP Redevelopment Code Page | 100 11.4 Highway Monument Sign Location Standards (a) IH-35W and, Hwy 10 and MN-96 Frontages only a.Located within 60 ft. of the edge of IH-35W or, Hwy 10 or MN- 96. b. Maximum height of 30 ft. above the street pavement grade of the elevated portion of the highway. c. Maximum total sign face area of 400 sq. ft (cumulative of all surfaces). Sign face may be divided into multiple segments. Area between segments does not count toward sign face area. d. One sign allowed for lots with at least 1,000 ft. of highway frontage. Two signs permitted for frontages greater than 1,000 ft. Signs to be a minimum of 1,000 ft. apart. 11.5 Corridor Monument Sign Location Standards (a) All per zoning district permitted i. Maximum area of 0.7 sq. ft. for each linear foot of street frontage with a maximum of 150 sq. ft. for multi-tenant signs. i.ii. Corridor Monument Sign not permitted for single-tenant buildings, instead multiple single tenants should be combined onto one (1) Corridor Monument Sign. ii.iii. One per lot. For lots with a total street frontage greater than 500 ft., two (2) signs are permitted. Signs must be a minimum of 400 ft. apart. iii.iv. For lots fronting two streets, one sign is permitted on each street. iv.v. Maximum height of 12 ft. above frontage street pavement grade. vi. Monument structure shall include a base, frame, and cap around the sign area. Material shall be the same as the principal structure on the lot. v.vii. Maximum total area shall not exceed 1.5 times the permitted sign copy area of a sign. 11.6 Building Identity Sign Location Standards (a) IH-35W, Hwy 10 and MN-96 Frontages only i. May be used for single tenant commercial, office or institutional buildings only (multiple tenant building shall be subject to 121.67 below). ii. May be used instead of a Building Projecting Sign or a Roof Sign iii. Maximum area of 200 sq. ft. or 15% of thelength of façade area, whichever is less. iv. Mount no lower than 25 ftin upper third of the facade. above finished grade. v.iv. No more than 25% of façade area above 25 ft. can contain Building Identity signs. (b) All frontages other than IH-35W, Hwy 10 and i. May be used for single tenant commercial, office or institutional buildings only (multiple tenant building shall be subject to 121.67 below). ii. May be used instead of a Building Projecting Sign iii. Maximum area of 150 sq. ft. or 102% of thelength of façade