Laserfiche WebLink
<br />n <br /> <br />Q <br /> <br />a <br /> <br />a <br />a <br /> <br />] <br />] <br /> <br />Q <br /> <br />II <br />a <br /> <br />u <br /> <br />a <br /> <br />o <br /> <br />o <br /> <br />o <br /> <br />o <br />o <br />o <br />o <br /> <br />Test Spec. Mode Test Procedure Expected Pass Fail Notes <br />10 Section Response <br /> 15950 . <br />s 3.D9 J SF Slatic HI Simulate static pressure 1" higher SF & RF shut down. X Nole 10 <br />CooL Umil than set point. <br /> OA & RE dampers close. X Note 10 <br /> Alarm to BAS X Note 10 <br />6 3.08 K Filter Alarm Simulate high differential Verify that BAS reports X Note 11 <br /> pressure across filters. an alarm. <br />7 3.08G FKeismoke Simulate fire/smoke concfotion. NOT Tested. <br /> <br />. <br /> <br />End Of Test <br /> <br />. <br /> <br />Notes: Testing of AHU ft2 was performed using HVACPro. <br />1. MaIn computer is not-.p for alarms. U.N.T. controner is not programmed properly, presslKe win always read O. <br />2. Unable to lest because of outside air tempenllure. <br />3. Supply fan status does not work. Status continually shows 00. <br />4. Return fan, (IF-2) has no points on contro8er. <br />5. Unit continues 10 operate if either fan fails. <br />6. Controller is not programmed for _m up mode. <br />7_ Economizer mOOe is locked out on outside air temperature set point. <br />8. OX cooling is never locked out Outside air temperature is not being written to controne.. and set point for lockout is at 20". <br />g. low liniI protection device is wired to 1he supply fan sIaIus point. No alarm is generated. <br />10. Opening contacts diOOl shut down unit. No alarm is generated. <br />11. Main computer is not setup for alarms. U.N.T. controller is not programmed property. pressure win always read O.Fllter sIaIus is <br />not 00 computer. <br />12. Relief damper actuator is not instaUed. Damper is instatIed and in 1he open position. <br /> <br />. <br /> <br />File: AHU2_FinaIReport.doc <br /> <br />Page 6 of 6 <br />