Laserfiche WebLink
should be wall - mounted by this time. The four digits (or six digits if <br /> a 6 wheel register) that appear first on the Reader's screen should <br /> correspond to the meter's odometer reading. Depress the reading button <br /> to view the eight digit register Z.D. number. Record the reading and <br /> Z.D. number for the proper customer location (address) along with the <br /> meter's serial number. <br /> 7. After you have successfully read the meter from the touch pad and thus <br /> verified correct instal'-anon, seal wire the register top thru the sea- <br /> wires holes provided in the terminal cover. At the touch pad, fold the <br /> hinged screw covers into place and seal wire to secure. <br /> Illustration 2 - TOP VIEW (Terminal Cover Removed) <br /> e <br /> ® � G N <br /> oEeainc Ica CF <br /> C. Connection to the Meter Interface Unit (MIU) <br /> 1. Prepare the cable for installation at the MIU. <br /> a. Remove approximately 1 -1/2" of the outer jacket. <br /> b. strip 3/4" of insulation from two of the three conductors (remember <br /> what colors were hooked to the touch pad). <br /> c. Bend a loon in each bare wire. <br /> 2. Remove the cover of the MIU. <br /> 3. Beneath the cover, at the terminal, connect two conductors of 3- <br /> conductor_xire to locations marked "TP" and "TP" at Port 1 for 1 mete' <br /> and Port 2 for 2 meters. <br /> In either installation, make certain there is no bare wire -to -wire <br /> contact. <br /> Troubleshooting <br /> The following can be used as a guideline. <br /> A. If the display shows "E -1" for meter reading and "E -2" for I.D. number: <br />