2004-06-01 P & Z Packet - Laserfiche WebLink

Home Browse Search

Subd. 1. Height. No structures or other buildings may be erected to a height exceeding thirty-five (35) feet without the issuance of a Special Use Permit by the City. Subd. 2. Area and Width. No dwelling may be constructed or placed on a lot of less than 7,500 square feet or less than 60 feet in width at the building setback line. Subd.3. Minimum Floor Area. The minimum building size in the R-4 District is 1,050 SF. All dwellings shall have a minimum width of twenty-four (24) feet at its narrowest point, with the exception of the M-1 District. Subd.4. Special Requirements of the Zoning District. Manufactured homes are permitted in all residential districts if they meet the design criteria for such districts, as stated in Section 105 Definitions, Subd. 103. All other manufactured homes shall be located only in designated manufactured home districts, which meet the requirements of this Ordinance. No person shall erect, establish, extend or enlarge a manufactured housing development within the city limits of the City of Centerville without first submitting a Site Plan for review by the Planning and Zoning Commission and approval from the City Council. Approval shall be granted only upon compliance with the following: 1. Compliance with the requirements of the City's Zoning Ordinance #4; 2. Compliance with the requirements of the City's Ordinance #8, Regulation the Subdivision and Platting of Land; 3. Compliance with the requirements of the City's Ordinance #3, Subdivision; The proposed development must be served by public utilities as approved by the City Council. Comer lots shall not have anything erected, placed, planted or allowed to grow in such a manner as to materially impede sight lines between a height of two and one-half (2 12) and ten (10) feet above the centerline grades of the intersecting streets in a triangle bounded by the street of the lot and a line joining points along the street lines fifty (50) feet from the point of the intersection.