Laserfiche WebLink
ROBERT A. JON�S `:` <br />• � CDNSULTINCi ENCi1NELRS ; �,% <br />LA GRANGE. Il.L1W018 <br />. �.'..r..i='' <br />� Page 3 ` <br />� of his televisioiz set, and the comparative observations of �kh� owner'�` -; <br />set and our tes� set on each of th� standard VHF channels. `;r <br />The equipment employed consisted of a Zenith 12��s�alid state ` <br />portable televi.sion receiver. This was i�iodel No. R1290L5, Serial No. <br />5376364, and was purchased new in December, :196i, immediately prior <br />to this survey. A Zenith AM/�"M radio model Royal 820, was used to ` <br />� `; <br />monitor AM and FM Lroadcast signals and to check for exc�sssive n�ise <br />levels. This radio wa� capable of operating on either AC mean� or <br />batteries. Also employed was a Sony Video Tage Recordez, ca�able of <br />recorda.ng off-the-air signals and used for comparing "before" and <br />"after'" observations. A Freeman; Model 660, tape rec:order was avaa.l� " <br />able for recording any r�oise or unusual AM or FM in�terference �hat <br />hi-s eed film <br />might be found. In addition a Ciroflex camera, with p . <br />, <br />was available to record�directly off t�e television screen, �ny unusual ? <br />interferences not .recordable by the Sony Video tape recarder, ` <br />After completion of cor.struction and the energizing of said <br />345 kv line, the second part of the required surv�y t��as conducted. <br />For �I11S portion of the survey, only those homes, where entry was <br />permitted last winter, were contacted. It would have done no good <br />to inspect the homes where nobody was home before the 345 kv line <br />was constructed, the reason being that we would have had no basis f or � <br />comparison. The second part of the survey was conducted on September '. <br />30th., October 1, 2, 3, 7, $, 9 10 and llth., 1968. <br />The same equipment was emp.byed here, as in the "before" survey, <br />� except in additie� a Log-periodic TV antenna, a 20 foot alumir�ium <br />mast and 100 feet of shield 300 ohm cable were used. This later mat- <br />