Laserfiche WebLink
<br /> I <br /> 5. Bottles are to be shut off and hoses drained when not being used. I <br /> 6. Roll up hoses and store on tank rack when not being used. -- <br /> 7. Store tips in proper place. <br /> 8. Proper starting up and shutting down of tanks will be followed and those I <br /> procedures shall be posted in the welding area. <br /> 9. Fire extinguisher will be close at hand. I <br /> O. Drill Press I <br /> I. Safety glasses, goggles or face shield will be used when operating this <br /> equipment. I <br /> 2. Wipe off press bench of metal chips and other debris. <br /> 3. Take drill bit out of chuck and put away in its place. I <br /> 4. Take chuck wrench out and put it on rack next to the press where it I <br /> belongs. <br /> 5. If cutting oil is used, wipe up after usage and store on table next to press. .. <br /> P. Heavy Equipment <br /> I <br /> Skid Steer, Tractor Backhoe, Front End Loader, Snow Plows etc. <br /> I. Operator is required to perform walk around inspections daily, checking I <br /> and performing the following; but not limited to: <br /> a. Observe tires for cuts, bulges, and proper inflation. I <br /> b. Check and top off all oil reservoirs. I <br /> c. Lubricate all grease points as necessary. <br /> d. Notify maintenance department when maintenance and service I <br /> work is needed. <br /> e. Check back-up alarm. I <br /> f. Clean windows as necessary. I <br /> 19 .. <br /> I <br />