Laserfiche WebLink
<br />. <br /> <br />. <br /> <br />. <br /> <br />ARDEN HILLS PLANNING COMMISSION - MARCH 7, 2001 <br /> <br />17 <br /> <br />Case #01-05, Master Planned Unit Development ofthe properties located in the Northeast <br />quadrant ofI-694 and I-35W, with the following conditions: <br />1. The proposed document "Gateway Business Center--Arden Hills, MN, Proposed Planned <br />Unit Development Design Standards", revision dated March 7,2001, be amended <br />accordingly (additions are shown in CAPS, language removed is ,trickon): <br />a) Page I, Purpose and Intent, third line of the first paragraph should read, ",. ,consist of A <br />PREDOMINATELY office DEVELOPMENT and supporting ancillary uses.., "; <br />b) Page I, Permitted Uses, strike #1 relating to antennas and add it under Permitted Accessory <br />Uses; <br />c) Page I, Permitted Accessory Uses, #1 should read, "Any incidental assembly, repair, <br />processing, CLASS I manufacturing"." <br />d) Page 2, Permitted Accessory Uses, #7 should read, "Day Care Nursery WITH LESS THAN <br />TEN CHILDREN"; <br />e) Page 2, Lot Area, Lot Width, and yard Requirements, #1, should read, "Lot Area: One acre <br />minimum, NOT TO EXCEED TWO LOTS OF THIS SIZE" <br />f) Page 4, Building Design and Materials, #4, last line ofthe paragraph, should read, "" .ofthe <br />fayade. ACCESSORY BUlLDINGS SHALL MEET THE SAME BUlLDING MATERIAL <br />REQUlREMENTS AS PRINCIPAL BUlLDINGS, Allowable materials". "; <br />g) Page 4, Building Design and Materials, #4 B, should read as follows, "Secondary exterior <br />building materials may be decorative block (LIMITED TO SINGLE STORY <br />STRUCTURES), integrally colored stucco, or heavy guage aluminum or prefinished <br />architectural metal panels OR EIFS (TO A MAXIMUM OF 10% OR THE STRUCTURE); <br />h) Page 5, Building Design and Materials, #4 C, should read as follows, "Synthetic stucco eF <br />ElliS (Exterior Insulation ami Finish Systems) may be permitted as a secondary material on <br />upper floors only"; <br />i) Page 5, Building Design and Materials, #4 F, should be stricken completely; <br />j) Page 5, Building Design and Materials, #10 should be stricken completely; <br />k) Page 5, Building Design and Materials, #11, second line, should read as follows, <br />"" ,submitted for staff PLANNING COMMISSION review AND CITY COUNCIL <br />APPROVAL at the time of submittal for building permit(s) FINAL PUD"; <br />I) Page 6, parking Requirements, #3, second line should read, ".. ,shall be screened with a <br />decorative wall OF COMPATIBLE MATERIALS..,"; <br />m) Page 6, Loading Docks, third line, should read, "" .by means oflandscaping which is at least <br />80% opaque within two years eF AND by a screen walL,," and <br />n) Pages 8 and 9, Signage, be removed in its entirety from the document for review during the <br />final PUD process, with the exception of#2 J, which should read as follows, "Temporary <br />leasing signs and marketing signs will be allowed AS RECOMMENDED TO CITY <br />COUNCIL BY STAFF". <br />2. Maximum office component requirement be increased from 50% to 100% as per the <br />"Variance Requests and Findings, (a)" section of the staff memorandum; <br />3. Minimum building size be reduced from 20,000 square feet to 6,000 square feet, as per the <br />"Variance Requests and Findings, (b)" section of the staff memorandum, allowing no more <br />than two structures of this size on the property; <br />4. Maximum building height be increased from 35 feet to eight stories as per the "Variance <br />Requests and Findings, (c)" section of the staffmemorandlUll; <br />5. Parking ramps/decks be permitted within the front yard setback and the side yard/comer <br />setback as per the "Variance Requests and Findings, (d)" section of the staff memorandum; <br />6. Side yard interior and comer setbacks for the principal structure(s) must meet the <br />requirements of the Gateway Business District and are not permitted as proposed to be <br />decreased to 10' on the interior (where 20' is required) and 20' on the comer (where 50' is <br />